A team of University of Arkansas physicists has successfully developed a circuit capable of capturing graphene’s thermal motion and converting it into an electrical current.
“An energy-harvesting circuit based on graphene could be incorporated into a chip to provide clean, limitless, low-voltage power for small devices or sensors,” said Paul Thibado, professor of physics and lead researcher in the discovery.
The findings, published in the journal Physical Review E, are proof of a theory the physicists developed at the U of A three years ago that freestanding graphene — a single layer of carbon atoms — ripples and buckles in a way that holds promise for energy harvesting.
The idea of harvesting energy from graphene is controversial because it refutes physicist Richard Feynman’s well-known assertion that the thermal motion of atoms, known as Brownian motion, cannot do work. Thibado’s team found that at room temperature the thermal motion of graphene does in fact induce an alternating current (AC) in a circuit, an achievement thought to be impossible.
In the 1950s, physicist Léon Brillouin published a landmark paper refuting the idea that adding a single diode, a one-way electrical gate, to a circuit is the solution to harvesting energy from Brownian motion. Knowing this, Thibado’s group built their circuit with two diodes for converting AC into a direct current (DC). With the diodes in opposition allowing the current to flow both ways, they provide separate paths through the circuit, producing a pulsing DC current that performs work on a load resistor.
Additionally, they discovered that their design increased the amount of power delivered. “We also found that the on-off, switch-like behavior of the diodes actually amplifies the power delivered, rather than reducing it, as previously thought,” said Thibado. “The rate of change in resistance provided by the diodes adds an extra factor to the power.”
The team used a relatively new field of physics to prove the diodes increased the circuit’s power. “In proving this power enhancement, we drew from the emergent field of stochastic thermodynamics and extended the nearly century-old, celebrated theory of Nyquist,” said coauthor Pradeep Kumar, associate professor of physics and coauthor.
According to Kumar, the graphene and circuit share a symbiotic relationship. Though the thermal environment is performing work on the load resistor, the graphene and circuit are at the same temperature and heat does not flow between the two.
Thibado’s energy-harvesting circuit uses the atomic motion of graphene to generate an electrical current that can perform work. Illustration by Ashley Acord.
That’s an important distinction, said Thibado, because a temperature difference between the graphene and circuit, in a circuit producing power, would contradict the second law of thermodynamics. “This means that the second law of thermodynamics is not violated, nor is there any need to argue that ‘Maxwell’s Demon’ is separating hot and cold electrons,” Thibado said.
The team also discovered that the relatively slow motion of graphene induces current in the circuit at low frequencies, which is important from a technological perspective because electronics function more efficiently at lower frequencies.
“People may think that current flowing in a resistor causes it to heat up, but the Brownian current does not. In fact, if no current was flowing, the resistor would cool down,” Thibado explained. “What we did was reroute the current in the circuit and transform it into something useful.”
The team’s next objective is to determine if the DC current can be stored in a capacitor for later use, a goal that requires miniaturizing the circuit and patterning it on a silicon wafer, or chip. If millions of these tiny circuits could be built on a 1-millimeter by 1-millimeter chip, they could serve as a low-power battery replacement.
The Latest Updates from Bing News & Google News
Go deeper with Bing News on:
- Demonstration Streeton November 17, 2020 at 4:00 pm
Applicants should have a working prototype or commercial product to show that demonstrates new advances in any of the related event topics of: energy storage, electric vehicles, graphene ... (products ...
- Graphene Generates A Little Poweron November 17, 2020 at 4:00 pm
We aren’t quite sure what to make of a press release from the University of Arkansas claiming they can draw current from a sheet of freestanding graphene purely from its temperature fluctuations.
- Common Adhesive Tape Used to Build a Better Batteryon November 17, 2020 at 4:00 pm
Related: AI Predicts Battery Health Researchers were inspired to use the tape from previous attempts to produce free-standing films of laser-induced graphene, they said. Unlike pure polyimide films, ...
- Producing materials to help break the electronics scaling limiton November 13, 2020 at 6:16 am
of which graphene may be the most well-known example, offer the promise to solve this scaling issue. Characteristic of these materials is that each layer of atoms is free-standing on the layer of ...
- Hydroplastic foaming of graphene aerogels and artificially intelligent tactile sensorson November 11, 2020 at 11:15 pm
Here, we invent a hydroplastic foaming method to directly convert graphene oxide solids into aerogel bulks and microarrays, replacing the prevalent freezing method. The water intercalation plasticizes ...
Go deeper with Google Headlines on:
Go deeper with Bing News on:
- Simple Yet Robust Triboelectric Harvester Powers Sweat-Sensing Patchon November 25, 2020 at 7:08 am
Researchers devised an innovative and easy-to-fabricate, rugged triboelectric energy harvester to power an integrated, skin-attached sweat sensor that also includes a Bluetooth-based data link.
- Controlling fully integrated nanodiamondson November 23, 2020 at 4:18 am
(Nanowerk News) Physicists at Münster University have succeeded in fully integrating nanodiamonds into nanophotonic circuits and at the same time addressing several of these nanodiamonds optically.
- How Energy Harvesting is Enabling New Possibilities for Medical Wearable Deviceson November 19, 2020 at 2:24 pm
Healthcare facilities and hospitals use connected IoT devices for a wide range of use cases, including giving wearable medical devices to patients as an easy way to monitor their from anywhere.
- Vibration Energy Harvesting Market Revenue Insighton November 19, 2020 at 7:30 am
Vibration Energy Harvesting report can be used by market ... Power Management Integrated Circuit (PMIC), Secondary Battery), Sensor Type (Wireless Sensor Network (WSN), Others), Application ...
- Recloser Market Trends and Dynamics 2029 | NOJA Power Switchgear Pty Ltdon November 19, 2020 at 4:51 am
Reclosers refer to circuit breakers, which are mounted on long distribution feeders. The capability of circuit breakers to isolate or cut-off a part of the entire line in case of failures and ...