An accurate method for spacecraft navigation takes a leap forward today as the National Physical Laboratory (NPL) and the University of Leicester publish a paper that reveals a spacecraft’s position in space in the direction of a particular pulsar can be calculated autonomously, using a small X-ray telescope on board the craft, to an accuracy of 2km.
The method uses X-rays emitted from pulsars, which can be used to work out the position of a craft in space in 3D to an accuracy of 30 km at the distance of Neptune. Pulsars are dead stars that emit radiation in the form of X-rays and other electromagnetic waves. For a certain type of pulsar, called ‘millisecond pulsars’, the pulses of radiation occur with the regularity and precision of an atomic clock and could be used much like GPS in space.
The paper, published in Experimental Astronomy, details simulations undertaken using data, such as the pulsar positions and a craft’s distance from the Sun, for a European Space Agency feasibility study of the concept. The simulations took these data and tested the concept of triangulation by pulsars with current technology (an X-ray telescope designed and developed by the University of Leicester) and position, velocity and timing analysis undertaken by NPL. This generated a list of usable pulsars and measurements of how accurately a small telescope can lock onto these pulsars and calculate a location. Although most X-ray telescopes are large and would allow higher accuracies, the team focused on technology that could be small and light enough to be developed in future as part of a practical spacecraft subsystem. The key findings are:
– At a distance of 30 astronomical units – the approximate distance of Neptune from the Earth – an accuracy of 2km or 5km can be calculated in the direction of a particular pulsar, called PSR B1937+21, by locking onto the pulsar for ten or one hours respectively
– By locking onto three pulsars, a 3D location with an accuracy of 30km can be calculated
This technique is an improvement on the current navigation methods of the ground-based Deep Space Network (DSN) and European Space Tracking (ESTRACK) network as it:
– Can be autonomous with no need for Earth contact for months or years, if an advanced atomic clock is also on the craft. ESTRACK and DSN can only track a small number of spacecraft at a time, putting a limit on the number of deep space manoeuvres they can support for different spacecraft at any one time.
– In some scenarios, can take less time to estimate a location. ESTRACK and DSN are limited by the time delay between the craft and Earth which can be up to several hours for a mission at the outer planets and even longer outside the solar system.
Dr Setnam Shemar, Senior Research Scientist, NPL, said: “Our capability to explore the solar system has increased hugely over the past few decades; missions like Rosetta and New Horizons are testament to this. Yet how these craft navigate will in future become a limiting factor to our ambitions. The cost of maintaining current large ground-based communications systems based on radio waves is high and they can only communicate with a small number of craft at a time. Using pulsars as location beacons in space, together with a space atomic clock, allows for autonomy and greater capability in the outer solar system. The use of these dead stars in one form or another has the potential to become a new method for navigating in deep space and, in time, beyond the solar system.”
Dr John Pye, Space Research Centre Manager, University of Leicester, concludes:
“Up until now, the concept of pulsar-based navigation has been seen just as that – a concept. This simulation uses technology in the real world and proves its capabilities for this task. Our X-ray telescope can be feasibly launched into space due to its low weight and small size; indeed, it will be part of a mission to Mercury in 2018. NPL’s timing analysis capability has been developed over many years due to its long heritage in atomic clocks. We are entering a new era of space exploration as we delve deeper into our solar system, and this paper lays the foundations for a potential new technology that will get us there.”
The Latest on: Autonomous interplanetary travel
via Google News
The Latest on: Autonomous interplanetary travel
- Destination Titanon March 19, 2020 at 1:44 pm
They settled on a system that combines a drill with a pneumatic transfer system that would suck particles off the ground using an approximately 2-inch drill bit and a sort of interplanetary shop-vac .
- Autonomous Boat Sails The High Season March 17, 2020 at 5:00 pm
To study them in-depth will require robots, and for that reason [Mike] has created an autonomous boat. This boat is designed to be 3D printed in sections, making it easily achievable for anyone ...
- Yanking on the space supply chain: Rocket Lab goes Interplanetary with Sinclair acquisitionon March 16, 2020 at 8:19 am
Flinger of small satellites Rocket Lab has made a move to tighten up its supply chain with the acquisition of Toronto-based Sinclair Interplanetary ... the Cislunar Autonomous Positioning System ...
- Adding An Optical Mouse Sensor To An Autonomous Vehicleon March 15, 2020 at 5:00 pm
He has a pretty good start, but was having some problems accurately measuring travel distance ... he’s experimenting with adding an optical mouse sensor to the autonomous vehicle.
- These two tiny spacecraft will help pave the way for astronauts to return to the moonon March 13, 2020 at 11:10 am
NASA has announced the first two such projects selected to fly as part of the Artemis program to land astronauts on the moon: Lunar Flashlight and the Cislunar Autonomous Positioning System ...
- India’s MOM spacecraft arrives at Marson March 1, 2020 at 4:00 pm
to continue what has so far been a successful technology demonstration mission to showcase India’s entry in the realm of interplanetary ... the craft’s line of travel. Once in the proper ...
- The Moon, Mars, & around the Earth – Musk updates BFR architecture, planson March 1, 2020 at 4:00 pm
BFR would then use its Raptor engines to perform a Trans-Lunar Injection burn, travel to the moon ... the first two BFR missions in the 2022 interplanetary alignment and launch window to Mars.
- Relativity Space Secures New Headquarters Facility in the Heart of Southern California’s Next-Generation Aerospace Communityon February 27, 2020 at 4:00 pm
Autonomous Factory Will Produce World’s First 3D Printed Rocket In Long Beach Relativity Space, the first company to utilize additive manufacturing and robotics to build an entire launch vehicle, ...
- Human Exploration and Operations Mission Directorate Education Projectson December 7, 2016 at 12:11 pm
The purpose of the Exploration Higher Education Internship Grants is to train and develop ... The teams that can use telerobotic or autonomous operation to excavate the most lunar regolith simulant ...
via Bing News