A joint research team, affiliated with UNIST has introduced the Hybrid-Solid Electrolysis Cell (Hybrid-SOEC) system with highest reported electrochemical performance in hydrogen production. The proposed system has attracted much attention as a new promising option for the cost-effective and highly-efficient hydrogen production, as it shows excellent performance compared with other water-electrolysis systems.
This breakthrough has been led by Professor Guntae Kim in the School of Energy and Chemical Engineering at UNIST in collaboration with Professor Tak-Hyoung Lim of Korea Institute of Energy Research (KIER) and Professor Jeeyoung Shin of Sookmyung Women’s University.
A solid oxide electrolyzer cell (SOEC) consists of two electrodes and an electrolyte that are all in solid-state. They are strongly desired as novel candidates for the hydrogen production, as they require no need to replenish lost electrolytes, while eliminating the corrosion problems. Besides, SOECs also operate at relatively high temperatures (700-1000 °C), which helps to offer reduced electrical energy consumption.
The existing SOEC electrolytes allows the transport of either only one of the hydrogen or oxygen ions to the other electrode. For the cases like the SOEC electrolytes that transport oxygen ions, water electrolysis occurs at the anode and this results in the production of hydrogen. In contrast, the SOEC electrolytes that transport hydrogen ions cause water electrolysis to occur at the cathode and this results in the production of oxygen. Here, hydrogen travels through the electrolyte to the anode.
Theoretically, using electrolytes that transport both hydrogen and oxygen ions, allows the production of two electrolysis products, hydrogen and oxygen, on both sides of the cell. This could improve hydrogen production rate greatly. In the study, the research team paid attention to the control of properties of electrolytes.
In comparison to other SOECs and representative water-electrolysis devices reported in the literatures, the proposed system demands less electricity for hydrogen production, while exhibiting outstanding electrochemical performance with stability. Moreover, the Hybrid SOEC exhibits no observable degradation in performance for more than 60 hours of continuous operation, implying a robust system for hydrogen production.
“By controlling the driving environment of the hydrogen ion conductive electrolyte, a ‘mixed ion conductive electrolyte’ in which two ions pass can be realized,” says Junyoung Kim in the doctoral program of Energy and Chemical Engineering, the first author of the study. “In Hybrid-SOEC where this electrolyte was first introduced, water electrolysis occurred at both electrodes, which results in significant increase in total hydrogen production.”
The layered perovskite with excellent electrochemical properties was used as the electrode of Hybrid-SOEC. By adding an excellent electrode material on mixed ionic conducting electrolyte, resulting in enhanced electrochemical performance. As a result, the corresponding yields of hydrogen produced were 1.9 L per hour at a cell voltage of 1.5 V at 700 °C. This is four times higher hydrogen production efficiency than the existing high-efficient water electrolytic cells.
Learn more: A New Strategy for Efficient Hydrogen Production
The Latest on: Hybrid-Solid Electrolysis Cell
- Hybrid solid-state system harvests more hydrogen from water on December 28, 2017 at 7:22 pm
running at a cell voltage of 1.5 V and a temperature of 700° C (1,292° F). The researchers say that's four times more efficient than existing water electrolysis systems, and after running the device c... […]
- NREL’s Advanced Atomic Layer Deposition Enables Lithium-Ion Battery Technology: on May 10, 2017 at 8:55 am
These lithium-ion batteries feature a hybrid solid-liquid electrolyte system ... electrodes to prevent "thermal runaway," or the uncontrolled increase in battery cell temperature that can result in a ... […]
- A Simple Approach for Molecular Controlled Release based on Atomic Layer Deposition Hybridized Organic-Inorganic Layers on January 20, 2016 at 4:00 pm
We synthesized drug loaded hybrid storage films containing fluorescein as a model substance by blending the molecule into the PEG and subsequently converting the polymer into a hybrid solid material . ... […]
- Major milestone in hydrogen research on December 6, 2004 at 4:00 pm
the University of Washington and Hoeganaes Corp. to continue work in the broad area of high-temperature electrolysis and fuel cell development. This new grant will work to enlarge by 100 times the siz... […]
via Google News and Bing News