FAU physicists demonstrate using a laser to control a current in graphene within just one femtosecond
Controlling electronic current is essential to modern electronics, as data and signals are transferred by streams of electrons which are controlled at high speed. Demands on transmission speeds are also increasing as technology develops. Scientists from the Chair of Laser Physics and the Chair of Applied Physics at Friedrich-Alexander-Universität Erlangen-Nürnberg (FAU) have succeeded in switching on a current with a desired direction in graphene using a single laser pulse within a femtosecond – a femtosecond corresponds to the millionth part of a billionth of a second. This is more than a thousand times faster compared to the most efficient transistors today.
Graphene is up to the job
In gases, insulating materials and semiconductors, scientists have already shown that it is possible to steer electrons with light waves and thus, in principle, to control current. However, this concept has not yet been applied to metals as light cannot usually penetrate the material to control the electrons inside. To avoid this effect, physicists in the working groups of Prof. Dr. Peter Hommelhoff and Prof. Dr. Heiko Weber used graphene – a semimetal consisting of only a single layer of carbon atoms. Even though graphene is an excellent conductor, it is thin enough to let some light penetrate the material and move the electrons.
For their experiments, the scientists fired extremely short laser pulses with specially engineered waveforms onto graphene. When these light waves hit the graphene, the electrons inside were hurled in one direction, like a whiplash. ‘Under intense optical fields, a current was generated within a fraction of an optical cycle – a half femtosecond. It was surprising that despite these enormous forces, quantum mechanics still plays a key role,’ explains Dr. Takuya Higuchi from the Chair of Laser Physics, the first author of the publication.
Two paths to the same destination
The researchers discovered that the current generation process in the graphene follows complicated quantum mechanics. The electrons travel from their initial state to the excited state by two paths rather than one – similar to a forked road leading to the same destination. Like a wave, the electrons can split at the fork and flow on both roads simultaneously. Depending on the relative phase between the split electron waves, when they meet again, the current can be very large, or not present at all. ‘This is like a water wave. Imagine a wave breaks against a building wall and flows to the left and the right of the building at the same time. At the end of the building, both parts meet again. If the partial waves meet at their peak, a very large wave results and current flows. If one wave is at its peak, the other at its lowest point, the two cancel one another out, and there is no current,’ explains Prof. Dr. Peter Hommelhoff from the Chair of Laser Physics. ‘We can use the light waves to regulate how the electrons move and how much electricity is generated.’
Will we see electronics controlled by light frequency in the future?
The results are another important step in bringing electronics and optics together. In the future, the method could open a door for realizing ultrafast electronics operating at optical frequencies.
Learn more: The fastest light-driven current source
The Latest on: Ultrafast electronics
Swinburne researchers contribute to newly launched FLEET Centre
on June 13, 2018 at 5:54 pm
Swinburne will contribute to research to create low-energy electronics with near-zero energy waste The Ultracold Atomic Gas Lab is paving the way for new discoveries in quantum technologies The Ultrafast Spectroscopy Lab uses light pulses quadrillionths of ... […]
Will 5G blow up the fronthaul network?
on June 11, 2018 at 10:02 am
We all know the 5G promise: ultra-fast speed and higher responsiveness (lower latency), but have you ever really thought about what that means to the network behind the cell tower? Several aspects of 5G are conspiring to potentially overwhelm the fronthaul ... […]
Count on it: Peering at atomic structures with no more than pencil and paper
on June 5, 2018 at 1:24 am
The simple strategy could help bring about ultrafast computer chips based on materials other ... offers a quick and easy procedure to zero in on promising materials for use in advanced electronics such as quantum computers that solve problems much more ... […]
Vodafone and Vocus to spend 'tens of millions' unbundling Chorus' fibre network
on June 4, 2018 at 3:57 pm
Vodafone chief executive Russell Stanners said the companies intended to spend "tens of millions of dollars" installing their own electronics on the ultrafast broadband (UFB) networks operated by Chorus, Enable, Waikato Networks and Northpower. […]
The interface between two tin-oxide semiconductors can exhibit unexpected metallic properties
on June 4, 2018 at 5:45 am
For example, they have great potential in electronics because they can be both transparent and flexible. They can exhibit magnetic properties, which opens the door to high-performance, ultrafast computer memories. They can be sensitive to their environment ... […]
Making massive leaps in electronics at nano-scale
on May 23, 2018 at 2:58 pm
This facility is dedicated to novel nano-electronics and it was initiated by the NRF Nanotechnology ... "Ncube's research established the great potential of carbon nanotubes for ultra-fast switching device and magnetic memory applications, a realisation ... […]
First Littelfuse SiC MOSFET Provides Ultra-Fast Switching in Power Electronics
on June 14, 2017 at 12:00 pm
Littelfuse, Inc., the global leader in circuit protection, today introduced its first series of silicon carbide (SiC) MOSFETs, the latest addition to the company’s growing power semiconductor line. In March, Littelfuse took another incremental step ... […]
High-Energy Electrons Probe Ultrafast Atomic Motion
on February 7, 2017 at 6:30 am
A new ultrafast technique, using high-energy electrons coupled to a laser pump, revealed insights into atomic vibrational dynamics in a laser-heated gold thin film. This technique directly measured the phonon spectrum (quantized packets of energy related ... […]
Graphene may power ultra-fast, next-gen electronics
on December 26, 2016 at 9:29 am
LONDON: Graphene - often touted as the 'wonder material' - can transmit extremely high currents, making it a potential building block for next-generation ultra-fast electronics, scientists say. Researchers from Technische Universitat Wien (TU Wien) in ... […]
Graphene may power ultra-fast, next-gen electronics
on December 25, 2016 at 4:00 pm
Graphene – often touted as the ‘wonder material’ – can transmit extremely high currents, making it a potential building block for next-generation ultra-fast electronics, scientists say. Researchers from Technische Universitat Wien (TU Wien) in ... […]
via Google News and Bing News