New chemistry could overcome key drawbacks of lithium-air batteries.
Lithium-air batteries are considered highly promising technologies for electric cars and portable electronic devices because of their potential for delivering a high energy output in proportion to their weight. But such batteries have some pretty serious drawbacks: They waste much of the injected energy as heat and degrade relatively quickly. They also require expensive extra components to pump oxygen gas in and out, in an open-cell configuration that is very different from conventional sealed batteries.
But a new variation of the battery chemistry, which could be used in a conventional, fully sealed battery, promises similar theoretical performance as lithium-air batteries, while overcoming all of these drawbacks.
The new battery concept, called a nanolithia cathode battery, is described in the journal Nature Energy in a paper by Ju Li, the Battelle Energy Alliance Professor of Nuclear Science and Engineering at MIT; postdoc Zhi Zhu; and five others at MIT, Argonne National Laboratory, and Peking University in China.
One of the shortcomings of lithium-air batteries, Li explains, is the mismatch between the voltages involved in charging and discharging the batteries. The batteries’ output voltage is more than 1.2 volts lower than the voltage used to charge them, which represents a significant power loss incurred in each charging cycle. “You waste 30 percent of the electrical energy as heat in charging. … It can actually burn if you charge it too fast,” he says.
Conventional lithium-air batteries draw in oxygen from the outside air to drive a chemical reaction with the battery’s lithium during the discharging cycle, and this oxygen is then released again to the atmosphere during the reverse reaction in the charging cycle.
In the new variant, the same kind of electrochemical reactions take place between lithium and oxygen during charging and discharging, but they take place without ever letting the oxygen revert to a gaseous form. Instead, the oxygen stays inside the solid and transforms directly between its three redox states, while bound in the form of three different solid chemical compounds, Li2O, Li2O2, and LiO2, which are mixed together in the form of a glass. This reduces the voltage loss by a factor of five, from 1.2 volts to 0.24 volts, so only 8 percent of the electrical energy is turned to heat. “This means faster charging for cars, as heat removal from the battery pack is less of a safety concern, as well as energy efficiency benefits,” Li says.
This approach helps overcome another issue with lithium-air batteries: As the chemical reaction involved in charging and discharging converts oxygen between gaseous and solid forms, the material goes through huge volume changes that can disrupt electrical conduction paths in the structure, severely limiting its lifetime.
The secret to the new formulation is creating minuscule particles, at the nanometer scale (billionths of a meter), which contain both the lithium and the oxygen in the form of a glass, confined tightly within a matrix of cobalt oxide. The researchers refer to these particles as nanolithia. In this form, the transitions between LiO2, Li2O2, and Li2O can take place entirely inside the solid material, he says.
The nanolithia particles would normally be very unstable, so the researchers embedded them within the cobalt oxide matrix, a sponge-like material with pores just a few nanometers across. The matrix stabilizes the particles and also acts as a catalyst for their transformations.
Conventional lithium-air batteries, Li explains, are “really lithium-dry oxygen batteries, because they really can’t handle moisture or carbon dioxide,” so these have to be carefully scrubbed from the incoming air that feeds the batteries. “You need large auxiliary systems to remove the carbon dioxide and water, and it’s very hard to do this.” But the new battery, which never needs to draw in any outside air, circumvents this issue.
The new battery is also inherently protected from overcharging, the team says, because the chemical reaction in this case is naturally self-limiting — when overcharged, the reaction shifts to a different form that prevents further activity. “With a typical battery, if you overcharge it, it can cause irreversible structural damage or even explode,” Li says. But with the nanolithia battery, “we have overcharged the battery for 15 days, to a hundred times its capacity, but there was no damage at all.”
In cycling tests, a lab version of the new battery was put through 120 charging-discharging cycles, and showed less than a 2 percent loss of capacity, indicating that such batteries could have a long useful lifetime. And because such batteries could be installed and operated just like conventional solid lithium-ion batteries, without any of the auxiliary components needed for a lithium-air battery, they could be easily adapted to existing installations or conventional battery pack designs for cars, electronics, or even grid-scale power storage.
Because these “solid oxygen” cathodes are much lighter than conventional lithium-ion battery cathodes, the new design could store as much as double the amount of energy for a given cathode weight, the team says. And with further refinement of the design, Li says, the new batteries could ultimately double that capacity again.
All of this is accomplished without adding any expensive components or materials, according to Li. The carbonate they use as the liquid electrolyte in this battery “is the cheapest kind” of electrolyte, he says. And the cobalt oxide component weighs less than 50 percent of the nanolithia component. Overall, the new battery system is “very scalable, cheap, and much safer” than lithium-air batteries, Li says.
The team expects to move from this lab-scale proof of concept to a practical prototype within about a year.
“This is a foundational breakthrough, which may shift the paradigm of oxygen-based batteries,” says Xiulei Ji, an assistant professor of chemistry at Oregon State University, who was not involved in this work. “In this system, commercial carbonate-based electrolyte works very well with solvated superoxide shuttles, which is quite impressive and may have to do with the lack of any gaseous O2 in this sealed system. All active masses of the cathode throughout cycling are solid, which presents not only large energy density but compatibility with the current battery manufacturing infrastructure.”
The research team included MIT research scientists Akihiro Kushima and Zongyou Yin; Lu Qi of Peking University; and Khalil Amine and Jun Lu of Argonne National Laboratory in Illinois. The work was supported by the National Science Foundation and the U.S. Department of Energy.
The Latest on: Lithium-oxygen battery
via Google News
The Latest on: Lithium-oxygen battery
- Lithium oxygen electrode development could bring smaller EV batteries on February 15, 2019 at 3:54 am
Nanoengineered transition metal oxygen electrodes may be able to boost lithium oxygen battery current output by orders of magnitude and extend electric vehicle ranges to 500 miles. Electric vehicles u... […]
- What does it take to make a better battery? on February 12, 2019 at 11:27 am
False-colour microscopic view of a reduced graphene oxide electrode (black, centre), which hosts the large (on the order of 20 micrometers) lithium hydroxide particles (pink) that form when a lithium- ... […]
- Hybrid planes could shorten the leap to all-electric 737s on February 11, 2019 at 8:16 am
Even next-generation battery chemistries, like lithium sulfur and lithium oxygen, aren't likely to reach that threshold write the authors, Venkat Viswanathan, a battery expert at Carnegie Mellon Unive... […]
- Research into lithium-oxygen batteries could boost performance of electronics on February 1, 2019 at 9:12 am
New research at the University of Kansas could provide longer-lasting batteries for the majority of electronics and electronic vehicles in the future. Assistant Professor of Mechanical Engineering, Xi... […]
- Research into lithium-oxygen batteries could boost performance of electronics, cars on January 29, 2019 at 8:00 am
Battery design will focus on the oxygen electrode (~1.2 cm diameter and 0.4 mm thickness). Credit: Xianglin Li Sick of having to plug in your phone every night? Help might be on the way. New research ... […]
- Lithium-Air Might Be The Better Battery on January 25, 2019 at 4:00 pm
Researchers at Cambridge University demonstrated their latest version of what is being called the Lithium-Air battery. It can be more accurately referred to as a Lithium-Oxygen but Air sounds cooler. ... […]
- Lithium-Air Batteries With 5x Energy Density Lithium-Ion Batteries on January 25, 2019 at 4:00 pm
Originally published on EV Obsession. A new lithium-oxygen battery design based around the use of lithium superoxide (LiO2) — promising an energy density up to 5 times higher than that of conventional ... […]
- Lithium-oxygen batteries broach 100% coulombic efficiency on September 4, 2018 at 10:51 am
If you’re reading this with a rechargeable battery powered appliance, the chances are it’s a lithium-ion battery based on intercalation chemistry. But with increasing demands for higher energy density ... […]
- Lithium-oxygen battery could save our future devices on August 25, 2018 at 5:03 am
There's a new solution being developed to cut down the charging sessions of smartphones and electric vehicles. The researches developed a way to convert the strength of lithium-oxygen combination into ... […]
- Step towards creating a rechargeable lithium-oxygen battery on August 24, 2018 at 4:08 pm
Chemists have reported on an important breakthrough on the path towards creating a rechargeable lithium-oxygen battery. This is a challenging issue with energy technology. Researchers from the Univers... […]
via Bing News